PACCAR Corporation — Parameter Part Numbers

Multiplexed Electrical System Service Manual 7 PM819023/KM815057 (08/14/2012) 7 - 11 CECU Parameter Part Number Parameter Description Min. Value Max. Value Explanation Q30-1024-094 Head Lamp Type 0 40 Parameter controls the PWM activity of the headlamps. Value 0/Single means Single Sealed Beam Value 1/Dual means Dual Sealed Beam Value 2-9/reserved means reserved Value 10/PB means Replaceable Bulb Value 11-19/reserved means reserved Value 20/Integral means Integral Beam Pod Value 21-39/reserved means reserved Value 40/Integral means Integral Beam Pod HID Q30-1024-095 Starter RPM Protection Enable 0 1 Parameter controls whether the Starter will be disabled when the engine is running.

Value 0/Disabled means the engine RPM will be ignored when allowing the starter to engage. Value 1/Enabled means the engine RPM must be below 500 rpm for the starter to engage. Q30-1024-096 Starter In Gear Protection Enable 0 1 Parameter controls whether the starter will be disabled because of the transmission state. Value 0/Disabled means the starter will be enabled regardless of the transmission state. Value 1/Enabled means the starter will be disabled if the transmission is not in neutral (optional for manual transmissions). Q30-1024-097 Starter Overcrank Protection Enable 0 1 Parameter controls whether the starter will be disabled due to overuse.

Value 0/Disabled means the starter will not be disabled due to overuse Value 1/Enabled means the starter will be disabled if the starter is overused (cranking for 90s without sufficient cooldown). Q30-1024-099 PACCAR Lighting Model 0 5 Parameter controls the Lighting Model Value 0 = No Exterior Lighting Value 1 = KW BCAB Value 2 = PB BCAB Value 3 = KW NGP Value 4 = PB Value 5 = KW ECE Russian Homologation Q30-1024-101 Trailer Detect Enable 0 1 Parameter controls the Trailer Detect functionality. Value 0/Disabled means there is no addition diagnostics of the trailer connection. Value 1/Enabled means there is additional diagnostics of the trailer.

The operator will be warned if the trailer has become disconnected or is intermittently disconnecting while in motion Q30-1024-102 Turn Lamps Front Side Installed 0 1 Parameter controls the outputs for the front side turn lamps. Value 0/Disabled means with the hardware installed, the lamps will work, but the diagnostics will not (except short circuits) Value 1/Enabled means the outputs and diagnostics are enabled (mostly for the fender lamps for T660s). If it is enabled with no hardware installed, you will get constant open circuit errors.