PACCAR Corporation — Diagnostic Trouble Codes

Multiplexed Electrical System Service Manual 12 PM819023/KM815057 (08/14/2012) 12 - 13 DTC Input Received By Item / System Description Detailed Description 239601 Chassis Node Exterior Lighting - Left Turn Trailer Lamp Left trailer turn output general error This set of DTCs will be recorded when there is a problem with one of the Left Turn Trailer Lamp circuit. This could be caused by failed bulbs, wiring harness issues, or corroded connectors. Left turn trailer output from Pin 16 of the Chassis Node connector B.

239603 Left trailer turn output short to power 239605 Left trailer turn output under current or open circuit 239606 Left trailer turn output over current 239613 Left trailer turn output general error 239631 Left trailer turn output not available 239801 CECU Exterior Lighting - Right Turn Trailer Lamp Right trailer turn output general error This set of DTCs will be recorded when there is a problem with one of the Right Turn Trailer Lamp circuit. This could be caused by failed bulbs, wiring harness issues, or corroded connectors. Right turn trailer output from Pin 20 of the Chassis Node connector C.

239803 Right trailer turn output short to power 239805 Right trailer turn output under current or open circuit 239806 Right trailer turn output over current 239813 Right trailer turn output general error 239831 Right trailer turn output not available 240401 CECU Park Lamps Park lamp general error This set of DTCs will be recorded when there is a wiring problem between the Power distribution center and the CECU connector E pin 7.

240403 Park lamp short to power 240405 Park lamp open circuit 240406 Park lamp short to ground 240413 Park lamp bad reference voltage 240431 Park lamp chassis node lathches fault 257903 CECU Battery Current Open in ammeter sensor circuit This DTC will be recorded when the control unit sees an open at the ammeter sensor input. Some possible causes for this are a broken wire, corroded or disconnected connector, or sensor failure. 257904 CECU Battery Current Short in ammeter sensor circuit This DTC will be recorded when the control unit sees a short at the ammeter sensor input. Some possible causes for this are pinched wire, water in a connector, or sensor failure.

265106 Dome Lamp Dome lamp over current This DTC will be recorded when the control unit sees overcurrent on the dome lamp output circuit. Some possible cause for this are a short to ground in the circuit, a pinched wire or the wattage of the bulbs on in the circuit are exceeding the output capacity. 286302 Wiper Invalid range high speed wiper switch input This DTC will be recorded when the control unit sees an invalid voltage range on the high speed wiper switch input. Some possible causes are broken wire, corroded or disconnected connector or faulty turn stalk switch.

286303 Wiper Open in wiper relay output This DTC will be recorded when the control unit sees an open at the wiper output relay. Some possible causes for this are a broken wire, corroded or disconnected connector.