. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Engine Oil Pan, Add Oil WARNING engine is stopped and may cause serious burns. Wait for the oil 3 - 119 emperat mediately temperature to go down b efore performin g this op eration. 1. Open t he engine ho od. 2. Remov e dipstick (G ), and w ipe th e oil off with a cloth. 3. Fully in sert dipstick (G) into filler pipe, the n remove it. 4. The oil level should be between t he H and L marks on dipstick (G). If the oi l level is bel ow the L mark , add oil through oil f iller port (F). 5.
If the oi l is above th e H line, open drain va lve (P) at th e bottom of the e ngine oil pa n, drain the excess engine oil, then check the e il, the n check the oil l evel again. 6. If oil lev el is correct, securel y tigh ten the o il filler cap a nd close the eng REMARK When chec king the oil le vel afte r the e ngine ha s been oper ated, wait for at leas t 15 minutes after stopping th e engine before chec king. ine is at an angle, make it horizontal before checking. I f the mach ine is at an angle, m ake it horizon tal before ch ecking.