Yamaha YFZ350X — PERIODIC MAINTENANCE AND MINOR REPAIR

Be sure to match one of the projections on the carburetor cap with one of the slots on the se- curing plate. If the securing plate does not match a projection, tighten the carburetor cap until they align. Do not loosen the carburetor cap. CAUTION: ECB00501 6. Install the mixing chamber cap securing plate by installing the screw. Assembling and installing the carburetors Assemble and install both carburetors by the fol- lowing steps. 1. Install the needle valve and float. 2. Install the float chamber by installing the screws. 3. Install the carburetor and tighten the joint screws. 4. Assemble the throttle valve. 5.

Install the mixing chamber cap, and then tight- en it securely to the specified torque. Tightening torque: Mixing chamber cap: 4 Nm (0.4 m·kgf, 2.9 ft·lbf) 8-28 Adjusting the throttle cables 1. Move the throttle lever a few times. 8. Tighten the carburetor joint screws. 7. Tighten the mixing chamber cap securing plate screw to the specified torque. 1. Mixing chamber cap securing plate 2. Projection 3. Slot 4. Screw Tightening torque: Mixing chamber cap securing plate screw: 3.5 Nm (0.35 m·kgf, 2.5 ft·lbf) 4 1 2 3 11 10 9 8 7 6 5 4 3 2 1