Diesel particulate filter regeneration Drive Regeneration Soot from diesel combustion and engine oil ash is conti- nuously stored in the closed diesel particulate filter. In order to allow longer filter change intervals and a long filter service life, regular regeneration of the diesel particulate filter is required. Passive regeneration • Continuously, at exhaust temperatures > 250 °C • Without additional diesel injection • Initiated automatically, no action required from driver Active regeneration • Is required if the exhaust temperature is too low e.g.
ve- hicle at standstill or slow driving • Additional diesel injection to increase exhaust temperature • Can be stopped at any time using the inhibit switch to suit the type and location of vehicle operation • Initiated automatically, no action required from driver High exhaust temperatures pack the soot and engine oil ash and store it in compressed form at the end of the filter. This keeps the required exhaust back pressure within the permis- sible limits. Since the exhaust temperatures are not sufficient for passive regeneration in every driving situation, active regeneration may be carried out depending on the driving situation.
The system initiates regeneration automatically once a cer- tain quantity of soot or ash is stored. 1) Information field for regeneration messages Inhibit switch G54.30-3843-00 G54.25-3464-00 Introduction of the New Unimog Generation | Model Series 405 27 – This printout will not be recorded by the update service. Status: 03 / 2013 –