AIR MANAGEMENT SYSTEM CROSSOVER TUBE CROSSOVER TUBE Turbocharger Crossover Tube • Air from the low-pressure turbocharger compressor outlet is routed to the high- pressure turbocharger compressor inlet through the crossover tube. The crossover tube is sealed at the inlet of the high pressure turbocharger with an O-ring and at the low pressure compressor discharge with a press-in seal. If the crossover tube is removed, the seal and O-ring must be replaced. The Turbocharger Crossover Seal Remover/Installer (ZTSE4676) is required to remove and replace the seal. O-RING O-RING CROSSOVER TUBE SEAL CROSSOVER TUBE SEAL Turbocharger Mounting • The turbocharger is mounted to the engine at two points.
The low-pressure turbine housing is bolted to the high-pressure pump cover and the high-pressure turbine housing is bolted to the exhaust tube assembly. The two turbochargers are connected by the turbine-mating V-band clamp that allows for minor angular variances in the mounting surfaces. In addition, the oil drain tube assembly is made of three pieces, and allows for changes in the mounting points. OIL DRAIN OIL DRAIN ASSEMBLY ASSEMBLY HIGH PRESSURE HIGH PRESSURE TURBOCHARGER TURBOCHARGER MOUNTING MOUNTING POINT POINT TURBOCHARGER TURBOCHARGER LOW PRESSURE LOW PRESSURE Note:
Removal of the turbocharger will change the relationship of the two mounting points and require that a special mounting and torque sequence be used. See the Service Manual for further details. POINT POINT MOUNTING MOUNTING 46 International ® VT 275 V6 Engine