INJECTOR OPERATION OIL INLET FROM RAIL OIL INLET FROM RAIL Spool Valve The open and close coils move the spool valve from side to side using magnetic force. The spool valve has two positions. When the valve is in the open position, oil flows from the high pressure oil rail into the injector. When the valve is in the closed position, oil drains from the injector back to the crankcase. COIL COIL COIL COIL SPOOL SPOOL Intensifier Piston • Since the intensifier piston is approximately seven times greater in surface area than the plunger, the fuel pressure under the plunger is approximately seven times greater than the injection control pressure.
PISTON PISTON INTENSIFIER INTENSIFIER Barrel & Plunger The barrel and plunger of the injector is where high fuel pressure is generated by the movement of the plunger. PLUNGER PLUNGER • Plunger coating reduces the possibility of scuffing and poor performance. BARREL BARREL Nozzle The nozzle needle opens when fuel pressure, pushing on the bevel of the needle, is greater than the spring pressure holding the needle closed. At that point, the needle lifts and fuel under high pressure passes through the nozzle holes. FUEL INLET FUEL INLET NEEDLE NEEDLE NOZZLE NOZZLE NOZZLE HOLES NOZZLE HOLES 57 International ® VT 275 V6 Engine