International Trucks VT 275 — VT275 manual

LUBRICATION SYSTEM Oil Filter Base and Valves • Oil enters the filter base from the oil cooler through the anti-drain back valve. The valve is not spring loaded; instead the valve closes under its own weight when the engine is shut off. This keeps the oil in the filter housing from draining back into the lube system. ANTI-DRAIN BACK VALVE • The oil cooler bypass valve is in the filter base. This valve allows the oil to bypass the cooler when cooler inlet pressure is 25 psi higher than the unfiltered side of the oil filter. This protects the cooler from high- pressure during cold start up.

COOLER BYPASS VALVE COOLER BYPASS VALVE Reservoir and Screen The oil reservoir for the high-pressure oil pump is located under the oil cooler cover in the crankcase Vee. The reservoir holds approximately one quart after the cooler and cooler cover are put in place. The passage at the bottom of the reservoir is for oil feed to the high-pressure pump. The screen in the reservoir filters any large debris that may be in the oil before it gets to the high-pressure pump. HIGH PRESSURE RESERVOIR SCREEN 66 International ® VT 275 V6 Engine