UNIQUE REPAIR PROCEDURES Removing EGR Valve The EGR puller must be used when removing the EGR valve or the valve and intake manifold may be damaged. EGR VALVE PULLER EGR VALVE PULLER To remove the EGR valve, first remove the EGR valve mounting bolts that hold the valve to the intake manifold. Rotate the valve counterclockwise until the pins at the ends of the EGR puller arms will slip under the EGR valve housing tabs and into the holes. Hook the other end of the puller arms to the puller beam. Position the other two arms over the holes in the intake manifold. Turn the shaft clockwise to remove the EGR valve.
EGR VALVE EGR VALVE Injector Removal • After removing the valve cover, remove the rear port plug. The port plug may pull the case-to-head tube from the branch tube assembly. Remove the seven bolts that hold the oil rail to the rocker arm carrier. Pull the rail from the head. REAR PORT PLUG Oil is not drained from the rail prior to removal, so oil will leak from the rail as it is removed. RAIL BOLTS Note: The port plug and case-to-head tube's O-rings are not replaceable. The port plug and case-to-head tube must be replaced if the O-rings are damaged. Injector Connectors The injector connectors on the VT 275 pass through the rocker lever carrier.
Disconnect the injector harness from the injectors by depressing the metal bail on the harness connector body while pulling the harness connector from the injector. To remove the injector pass-through connector, use the Injector Connector Remover (ZTSE4650) or push the open end of a 12-point 19mm socket over the connector to release the clips. Carefully pull the connector body from the carrier. The injectors will be extracted when the injector hold-down clamp bolts are removed. 19mm 12 POINT INJECTOR PASS THROUGH International ® VT 275 V6 Engine 77