UNIQUE REPAIR PROCEDURES OIL INLET OIL INLET O-Ring Replacement Carefully remove and replace the external O-rings. The injector nozzle gasket can be installed using a 12-point 9mm deep-well socket. The socket is used to apply even pressure around the gasket during installation. CONNECTOR CONNECTOR O-RING O-RING The connector O-rings should be replaced each time the injector is removed from the cylinder head. O-RINGS O-RINGS INJECTOR PASS THROUGH INJECTOR PASS THROUGH Note: Do not attempt to remove the oil inlet O-ring. It is not replaceable. If the O- ring is damaged, the injector must be replaced. Do not pull on the wires while working on the injector.
NOZZLE GASKET NOZZLE GASKET Injector Installation • Lubricate the upper and lower O-rings on the body of the injector. Place the hold- down clamp lug into the notch of the injector body. Lower the injector into the bore and use a #40 Torx bit to tighten the bolt to the specified torque. Install the injector pass through connector into the carrier, making sure that the connector snaps in fully. PASS THROUGH CONNECTOR PASS THROUGH CONNECTOR Lubricate the internal O-ring at the top of the injector. HOLD HOLD DOWN DOWN CLAMP CLAMP Install the rail over the injectors and start the bolts by hand. Torque the rail bolts using the proper sequence.
Case-to-Head Tube Installation • If the tube does not pull out with the port plug it will need to be removed after the rail is removed using the Case-to-head Tube Removal Tool (ZTSE4694). Before installation, lubricate the O-rings on the case-to-head tube and port plugs. Push the port plug into the tube and insert into the oil rail. Torque the port plug to specification. REAR PORT PLUG REAR PORT PLUG CASE-TO-HEAD TUBE CASE-TO-HEAD TUBE Note: The O-rings are not serviceable. Inspect the O-rings and replace the case- to-head tube and port plug if the seals are damaged. 78 International ® VT 275 V6 Engine