International Trucks VT 275 — VT275 manual

UNIQUE REPAIR PROCEDURES Position Crankshaft for Rocker Removal Special Tool ZTSE4697 can be used to service the rocker arms, valve bridges or push rods. Rotate the crankshaft until the vibration damper dowel pin is in the twelve o'clock position. Wiggle the rocker arms for number 1 cylinder. If the rockers do not move freely, rotate the crankshaft one complete revolution. The rockers should now be loose on number 1 cylinder. Cylinders number 1, 2 and 4 can now be serviced. Rotate the crankshaft one revolution to service cylinders 3, 5 and 6. DOWEL PIN HOLE Installing Spring Compressor Base Remove the injector of the cylinder to be serviced.

Insert the injector's hold-down clamp into the base of tool. Install the assembly as if installing an injector. Snug the hold-down bolt but do not torque. Note: Use clean shop towels to plug any oil drain holes before removing any components. Compressor Plate • Install the valve spring compressor plate on top of the valve bridges. With the plate in position, install the compressor bolt. Turn the bolt with a hand wrench until the plate contacts the top of the base. The rocker arms may now be removed. If the valve bridges must be serviced, back out the compressor bolt and remove the plate to gain access. Reinstall the rocker arms using the compressor tool. Caution:

Be careful not to drop the rocker arm ball into the engine. International ® VT 275 V6 Engine 79