UNIQUE REPAIR PROCEDURES Installing Head and Carrier • Verify that the cylinder head dowel sleeves are installed in the crankcase. Install the new head gasket and two guide pins (locally made). Install the head and the four 8mm bolts across the top of the head. Install the push rods with copper ends to the rocker and the valve bridges in their proper location. INTAKE INTAKE ROCKER LEVER CARRIER ROCKER LEVER CARRIER EXHAUST ROCKER EXHAUST ROCKER ROCKER ROCKER Rotate the crankshaft until the damper dowel-pin hole is at six o'clock. Make sure the rocker arm carrier dowels are in the head and install the carrier.
Verify dowel engagement into the carrier as the head bolts are tightened to specifications. Intake Manifold Gaskets • The intake manifold gaskets must be oriented correctly upon reassembly. After the intake manifold is assembled to the engine, the gasket would be in the position as shown with the tabs facing up. To aid in reassembly, the gaskets can be held to the intake manifold by pushing the manifold bolts through the captured rubber washers on the gasket. TAB INTAKE MANIFOLD GASKET 81 International ® VT 275 V6 Engine