Cummins — 3666003

Bearings, Main C Series Page 1-22 Section 1 - Cylinder Block - Group 01 Tap the main bearing caps gently into position. NOTE: Make sure the bearing does not become dislodged from the cap. When seated, the main bearing cap bolts can be threaded by hand. Install a main bearing cap after each upper bearing is installed to keep the bearing in place while the other uppers are installed. NOTE: Do not tighten the main bearing cap capscrews to the final torque value at this time. Tighten the capscrews to an initial torque. Torque Value: 50 N•m [ 37 ft-lb ] NOTE: The thrust journal does not have tangs or slots. NOTE:

Make sure the number stamped on the main bearing cap is positioned facing the camshaft side of the cylinder block. Push the crankshaft toward the center of its end thrust position to allow clearance for the thrust bearing. Since the main bearing rollout tool, Part Number 3323818, cannot be used for the Number 1 main bearing, use a blunt object or screwdriver to push the bearing into position as the crankshaft is rotated.