C Series Bearings, Main Section 1 - Cylinder Block - Group 01 Page 1-23 Tighten the capscrews evenly following the sequence shown. Torque Value: Step1 50 N•m [ 37 ft-lb ] Step2 95 N•m [ 70 ft-lb ] Step3 60° turn. NOTE: The crankshaft must rotate freely after the main bearings have been tightened. Check the main bearing installation and the size of the main bearings if the crankshaft does not rotate freely. Measure the end clearance of the crankshaft as follows: Install a dial indicator onto the oil pan flange. Put the tip of the gauge against the crankshaft counterweight. Push the crankshaft toward the rear of the cylinder block. Set the dial indicator at zero.
Push the crankshaft toward the front of the cylinder block.