Bearings, Main C Series Page 1-24 Section 1 - Cylinder Block - Group 01 If the end clearance is less than 0.127 mm [0.005 in], do the following: Loosen the main bearing capscrews one turn. Push the crankshaft toward the front and then toward the rear of the cylinder block. Tighten the main bearing capscrews in the sequence shown. Torque Value: Step1 50 N•m [ 37 ft-lb ] Step2 95 N•m [ 70 ft-lb ] Step3 60° turn. Measure the crankshaft end clearance. Crankshaft End Clearance mm in 0.127 MIN 0.005 0.330 MAX 0.013 NOTE: Crankshafts that have been reground on the thrust bearing surfaces are marked for oversize thrust bearings on the rear crankshaft counterweight.
If the crankshaft counterweight is marked, check the thrust bearing part number to make sure the correct bearing size is used. Example: 0.010 = 0.25 mm [0.010 in]