C Series Camshaft Section 1 - Cylinder Block - Group 01 Page 1-25 If the crankshaft end play is more than 0.330 mm [0.013 in] new, or 0.533 mm [0.021 in] used, the crankshaft must be removed from the engine and replaced. Finishing Steps Install the oil suction tube. Refer to Procedure 007-035. Install the oil pan. Refer to Procedure 007-025. Fill the engine with lubricating oil. Refer to Procedure 007-037. NOTE: Use only Cummins™ approved lubricating oil for natural gas engines to prevent premature engine damage. Operate the engine until the coolant temperature reaches 82°C [180°F], and check for lubricating oil leaks.
Camshaft (001-008) General Information The camshaft is gear-driven from the crankshaft. A replaceable bushing is used for each of the camshaft journals. The camshaft has lobes to operate the intake and exhaust valves. The valve lobes contact the valve tappets, which operate the valves. The profile of the camshaft lobes is the same for all C Series engines.