Cummins — 3666003

C Series Crankshaft Seal, Front Section 1 - Cylinder Block - Group 01 Page 1-65 Crankshaft Seal, Front (001-023) General Information The front crankshaft seal is mounted in the front gear cover. A double-lipped Teflon™ seal is used. The sealing surface on the crankshaft must be clean and free of lubricating oil during assembly. Preparatory Steps Disconnect the batteries. Refer to Procedure 013-009 (Battery Cables and Connections) in Section 13. Remove the drive belt. Refer to Procedure 008-002 (Drive Belt, Cooling Fan) in Section 8. Remove the vibration damper. Refer to Procedure 001-052 (Vibration Damper, Viscous) in Section 1. Remove the front gear cover.

Refer to Procedure 001-031 (Gear Cover, Front) in Section 1. Remove While supporting the gear cover, remove the oil seal from the gear cover. Drive the oil seal from the back side of the cover toward the front side of the cover. Clean and Inspect for Reuse Clean the gear cover seal bore and the crankshaft surface of all oil, dirt, and seal residue.