Crankshaft Seal, Front C Series Page 1-66 Section 1 - Cylinder Block - Group 01 Inspect the crankshaft for excessive wear. If the crankshaft has excessive wear, a service wear sleeve is available. Install Leave the plastic pilot installation tool in the lubricating oil seal. Position the seal on the seal installer, Part Number 3824499, with the lubricating oil seal dust lip facing outward. Apply a bead of Loctite 277, or equivalent, to the outside diameter of the seal before installation. Properly support the front cover lubricating oil seal flange to prevent damage to the lubricating oil seal and front cover.
Press the lubricating oil seal into the front cover from the backside of the cover toward the front side of the cover. Press the lubricating oil seal until the service tool bottoms against the front cover. Finishing Steps Install the front gear cover. Refer to Procedure 001-031 (Gear Cover, Front) in Section 1. Install the vibration damper. Refer to Procedure 001-052 (Vibration Damper, Viscous) in Section 1. Install the drive belt. Refer to Procedure 008-002 (Drive Belt, Cooling Fan) in Section 8. Connect the batteries. Refer to Procedure 013-009 (Battery Cables and Connections) in Section 13. Operate the engine and check for leaks.