C Series Crankshaft Seal, Rear Section 1 - Cylinder Block - Group 01 Page 1-67 Crankshaft Seal, Rear (001-024) Preparatory Steps Disconnect the driveline and remove the transmission, if equipped; refer to the OEM's instructions. Remove the clutch and flywheel, if equipped. Refer to Procedure 016-005. Remove Drill two 3-mm [0.12-in] holes, 180 degrees apart, through the outside metal of the rear crankshaft seal. NOTE: Make sure not to damage the crankshaft when drilling the holes. Install a Number 10 sheet metal screw into a slide hammer, Part Number 3823822. Install the screw/slide hammer into the hole in the rear crankshaft seal. Remove the seal.
Clean CAUTION The seal lip and the sealing surface on the crankshaft must be free from all oil residue to prevent seal leaks. Use Scotch-Brite™ 7448, Part Number 3823258, and a soft cloth to clean and dry the rear crankshaft sealing surface.