Cummins — 3666003

Crankshaft Seal, Rear C Series Page 1-68 Section 1 - Cylinder Block - Group 01 Install NOTE: There are two rear seal configurations used: One for dry flywheel housings (1) One for wet flywheel housings (2). NOTE: The seal for dry flywheel housings has an aluminum case with a urethane coating. The seal for wet flywheel housings has a steel case with a silicone coating. Refer to the appropriate C Series Parts Catalog for the correct part number. Install the pilot and seal from the seal replacement kit onto the crankshaft. NOTE: For wet flywheel housings, apply a coat of mild soap to the outside of the seal case. NOTE:

For dry flywheel housings, nothing is required on the outside of the seal case. Push the seal onto the pilot and into the bore of the flywheel housing. Remove the pilot. NOTE: Make sure the seal is completely installed into the rear housing. Use the installation tool from the seal replacement kit to install the seal to the correct depth. To prevent damage to the seal, hit the installation tool alternately at the 12-o'clock, 3-o'clock, 6-o'clock and 9- o'clock positions.