C Series Crankshaft Wear Sleeve, Front Section 1 - Cylinder Block - Group 01 Page 1-69 Finishing Steps Install the flywheel and clutch, if equipped. Refer to Procedure 016-005. Install the transmission and driveline; refer to the OEM's instructions. Operate the engine until the coolant reaches 82°C [180°F], and check for leaks and proper operation. Crankshaft Wear Sleeve, Front (001-025) Preparatory Steps Remove the following: Drive belt. Refer to Procedure 008-002. Vibration damper. Refer to Procedure 001-052. Front gear cover. Refer to Procedure 001-031. Remove Do not nick or gouge the crankshaft with the chisel. If the crankshaft is damaged, it must be replaced. NOTE:
Use a hammer and chisel that is only as wide as the wear sleeve. CAUTION Make one or two chisel marks across the wear sleeve. This will expand the wear sleeve, allowing the sleeve to be removed. Clean and Inspect for Reuse Use Scotch-Brite™ 7448, Part No. 3823258, to remove any rust or other deposits from the crankshaft flange. Use a clean cloth to clean the crankshaft flange.