Cummins — 3666003

Crankshaft Wear Sleeve, Front C Series Page 1-70 Section 1 - Cylinder Block - Group 01 Inspect the seal contact area on the crankshaft for a wear groove. If the seal has worn a groove deep enough to be felt with a sharp object or fingernail, it will be necessary to install a wear sleeve to prevent an oil leak. The oil seal used with the wear sleeve has a larger inside area than the standard seal. The two seals are not interchangeable. Install Use the crankshaft front wear sleeve installation tool, Part No. 3823908, to install the wear sleeve to the correct position on the crankshaft. The tool kit consists of the following: 1. Driver - 1 2. Spacers - 2 3. Capscrews - M14x1.5x60 mm - 2 4.

Hair Pin Cotter Pins - 2 Apply a thin coat of clean engine oil to the inside of the driver and to the capscrew threads. Apply a thin coat of clean engine oil to the crankshaft flange.