C Series Crankshaft Wear Sleeve, Front Section 1 - Cylinder Block - Group 01 Page 1-71 Position the chamfered end of the wear sleeve onto the end of the crankshaft. Position the counterbore end of the driver onto the wear sleeve. Install two M14x1.5x60 mm capscrews (without spacers or hairpin cotter pins) through the driver and into the crankshaft capscrew holes. Align the wear sleeve and driver perpendicular with the crankshaft. Tighten the capscrews “finger-tight.” To prevent damage to the wear sleeve, do not exceed 1/2 of a revolution of each capscrew. CAUTION Alternately, tighten the capscrews until the sleeve is installed to a depth of approximately 16 mm [0.625 in]. Torque Value:
20 N•m [ 15 ft-lb ]