Cummins — 3666003

Crankshaft Wear Sleeve, Front C Series Page 1-72 Section 1 - Cylinder Block - Group 01 Remove the capscrews and install the spacer on each capscrew. Install the two M14x1.5x60 mm capscrews. Continue to tighten the capscrews alternately until the bottom of the driver contacts the end of the crankshaft. Remove the driver. NOTE: Use the hairpin cotter pins to secure the capscrews and spacers to the tool during storage. Clean the wear sleeve and crankshaft of any excess lubricants. NOTE: The wear sleeve and oil seal mating surface must be clean and dry to allow proper oil sealing.