C Series Cylinder Block Section 1 - Cylinder Block - Group 01 Page 1-73 Finishing Steps Install the following components: Front gear cover. Refer to Procedure 001-031. Vibration damper. Refer to Procedure 001-052. Fan pulley. Refer to Procedure 008-039. Drive belt. Refer to Procedure 008-002. Operate the engine and check for leaks. Cylinder Block (001-026) Clean Use a strong solution of hot water and detergent to clean the cylinder bores. Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause bodily injury. NOTE: Clean the cylinder bores immediately after being deglazed. WARNING Rinse the cylinder bores until the detergent is removed.
Dry the cylinder block with compressed air. When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use. Wear goggles and protective clothing to avoid personal injury. NOTE: Remove the tape that covers the tappet and lubricating oil holes after the cleaning process is complete. WARNING Check the cylinder bore cleanliness by wiping them with a white, lint-free, lightly oiled cloth. If grit residue is still present, repeat the cleaning process until all residue is removed. Wash the cylinder bores with solvent. Dry the cylinder block with compressed air.