Cylinder Liner C Series Page 1-80 Section 1 - Cylinder Block - Group 01 Inspect for cracks under the flange. Inspect the outside and seat area for excessive corrosion or pitting. NOTE: Pits must not be more than 1.6 mm [0.06 in] deep. Replace the liner if the pits are too deep or if the corrosion can not be removed with Scotch-Brite® 7448, Part Number 3823258. NOTE: Cylinder liner pitting is caused by poor coolant composition. Refer to the Operation and Maintenance Manual, GTA8.3 CM558/CM2358, Bulletin 4021640, for coolant specifications. Inspect the inside surface for vertical scratches deep enough to be felt with a fingernail. NOTE:
If a fingernail catches in the scratch, the liner must be replaced. Inspect the inside surface for scuffing or scoring. Inspect the inside surface for liner bore polishing. NOTE: A moderate polish produces a bright mirror finish in the worn area with traces of the original hone marks or an indication of an etch pattern. NOTE: A heavy polish produces a bright mirror finish in the worn area with no traces of hone marks or an etch pattern.