C Series Cylinder Liner Section 1 - Cylinder Block - Group 01 Page 1-81 Replace the liner if: A heavy polish is present over 20 percent of the piston ring travel area. Both moderate and heavy polish over 30 percent of the piston ring travel area and one half (15 percent) is heavy polish. Measure the liner inside diameter with dial bore gauge, Part Number 3375072, in four places 90 degrees apart at the top and bottom of the piston travel area. Cylinder Liner Inside Diameter mm in 114.00 MIN 4.488 114.04 MAX 4.490 Measure the outside diameter of the liner top press fit area.
Cylinder Liner Outside Diameter (Top Press Fit) mm in 130.938 MIN 5.1550 130.958 MAX 5.1558 Measure the cylinder liner bore in the block. Cylinder Liner Bore in Block (Press-Fit Bore) mm in 130.90 MIN 5.154 130.95 MAX 5.156