Piston C Series Page 1-102 Section 1 - Cylinder Block - Group 01 Preparatory Steps Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. WARNING WARNING To reduce the possibility of personal injury, avoid direct contact of hot oil with your skin. WARNING Some state and federal agencies have determined that used engine oil can be carcinogenic and cause reproductive toxicity. Avoid inhalation of vapors, ingestion, and prolonged contact with used engine oil.
If not reused, dispose of in accordance with local environmental regulations. Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. WARNING Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. WARNING This component or assembly weighs greater than 23 kg [50 lb]. To prevent serious personal injury, be sure to have assistance or use appropriate lifting equipment to lift this component or assembly. WARNING Close the fuel supply valve. Refer to the OEM service manual.
Disconnect the batteries. Refer to the OEM service manual. Drain the lubricating oil. Refer to Procedure 007-037 in Section 7. Remove the lubricating oil pan. Refer to Procedure 007-025 in Section 7. Drain the cooling system. Refer to Procedure 008-018 in Section 8. Drain the low temperature aftercooler (LTA) system. Refer to Procedure 008-134 in Section 8. Remove the cylinder head. Refer to Procedure 002-004 in Section 2. Remove and disassemble the piston and connecting rod assemblies. Refer to Procedure 001-054 in Section 1. Remove the piston rings. Refer to Procedure 001-047 in Section 1.