C Series Timing Pin Housing Section 1 - Cylinder Block - Group 01 Page 1-107 Measure the piston ring gap. To measure the piston ring gap, use the top end of a piston to align the piston rings in the wear area of the cylinder where used. A 80 mm [ 3.5 in ] Use a feeler gauge to measure the piston ring end gap. Replace the ring if it does not meet the following specifications: Ring Gap mm in Top 0.40 MIN 0.016 0.70 MAX 0.028 Intermediate 0.25 MIN 0.010 0.55 MAX 0.022 Oil Control 0.25 MIN 0.010 0.55 MAX 0.022 NOTE: Add 0.09 mm [0.004 in] for every 0.03 mm [0.001 in] of bore wear, up to the maximum bore wear limit.
Identify the ring sets for installation in the cylinder where the end gap was measured. Timing Pin Housing (001-049) Preparatory Steps Locate top dead center for cylinder number 1 by barring crankshaft slowly while pressing on engine timing pin. Service Tip: If the timing pin has been damaged and can not be used to locate top dead center, use the following steps to locate top dead center (TDC)..