Timing Pin Housing C Series Page 1-108 Section 1 - Cylinder Block - Group 01 Remove Remove the timing pin assembly and seal. Install The timing pin assembly is precisely located on the gear housing to correspond to Top Dead Center (TDC) for cylinder number 1. If a gear housing other than the original housing is installed, the timing pin assembly must be accurately aligned to correspond to TDC for cylinder number 1. CAUTION Failure to locate the timing pin assembly to TDC for cylinder number 1 will result in incorrect injection timing.
Verify that the number 1 cylinder is at or near TDC on the compression stroke by rotating the crankshaft until the engine timing pin engages in the camshaft gear hole or the hole is visible through the gear housing. Disengage the timing pin.