C Series Timing Pin Housing Section 1 - Cylinder Block - Group 01 Page 1-109 Fabricate and install a wire pointer for the front of the engine. This can be done by forming a piece of wire that can be tightened under one of the gear housing capscrews. The wire must extend from the gear cover to a place on the crankshaft vibration damper that is easily seen. Remove all injectors. Refer to Procedure 006-026 (Injector) in Section 6. This step is important to release cylinder pressure so the crankshaft can be rotated smoothly to locate TDC for cylinder number 1. Use tool, Part Number 3377371, Engine Barring Gear.
Rotate the crankshaft one-quarter revolution in the direction of normal engine rotation. Tighten the adjusting capscrew for the number 1 intake valve to zero (0) lash plus 5 turns. NOTE: Leave the adjusting screw in this position until TDC is established.