Cummins — 3666003

Timing Pin Housing C Series Page 1-110 Section 1 - Cylinder Block - Group 01 Use extreme care when rotating the crankshaft. Use of too much force could damage the valve or push rod. CAUTION Rotate the crankshaft slowly in the opposite direction of normal engine rotation until the piston touches the intake valve. Mark the vibration damper at the wire pointer. CAUTION Make sure that the piston touches the intake valve with approximately the same amount of force as in the previous step. Rotate the crankshaft in the direction of normal engine rotation until the piston touches the intake valve. Mark the vibration damper at the wire pointer.

Measure the distance and mark the vibration damper at one-half the distance between the two marks. This mark is the TDC mark. Completely loosen the intake valve adjusting screw. Failure to do so will result in damage to the intake valve or push rod when the crankshaft is rotated. CAUTION