Cummins — 3666003

C Series Timing Pin Housing Section 1 - Cylinder Block - Group 01 Page 1-111 Rotate the crankshaft in the direction of normal engine rotation until the pointer is aligned with the TDC mark; then rotate the crankshaft one additional revolution. The timing pin hole in the camshaft gear must be visible, or felt through the back side of the gear housing. If not, the crankshaft must be rotated one revolution in the direction of engine rotation. Install the o-ring into the groove on the timing pin assembly. Lubricate the o-ring with 15W-40 engine oil. Push the pin into the hole in the camshaft gear to align the housing. Hold the pin while tightening the Torx™ capscrews. Torque Value:

Timing Pin Torx™ Capscrew 8 N•m [ 71 in-lb ] Check the pin to be sure it did not slip out of the camshaft gear hole when the capscrews were tightened.