Cummins — 3666003

Vibration Damper, Rubber C Series Page 1-112 Section 1 - Cylinder Block - Group 01 To prevent damage to the pin and gear, be sure the timing pin is disengaged before rotating the crankshaft. CAUTION Finishing Steps Install the vibration damper and wire pointer. Install the gear cover. Refer to Procedure 007-017 (Lubricating Oil Filter Head (Remote Mounted)) in Section 7. Install the vibration damper. Refer to Procedure 007-016 (Lubricating Oil Filter Head, Aluminum (Remote Mounted)) in Section 7. Remove the wire pointer. Adjust overhead. Refer to Procedure 003-004 (Overhead Set) in Section 3. Install all injectors. Refer to Procedure 006-026 (Injector) in Section 6.

Operate the engine and check for leaks. Vibration Damper, Rubber (001-051) Preparatory Steps WARNING Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. Disconnect the batteries. Refer to the OEM service manual. Remove the fan drive belt. Refer to Procedure 008-002 in Section 8.