C Series Vibration Damper, Rubber Section 1 - Cylinder Block - Group 01 Page 1-113 Remove NOTE: The crankshaft speed indicator ring is part of the vibration damper assembly and should not be removed from the vibration damper. Remove the vibration damper/crankshaft speed indicator ring. Clean and Inspect for Reuse WARNING Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. Use soapy water to clean any oil from the vibration damper/crankshaft speed indicator ring. Dry the vibration damper/crankshaft speed indicator ring with compressed air.
Inspect the crankshaft speed indicator ring for missing teeth, cracks, or damaged surfaces. If any damage is found, the crankshaft speed indicator ring must be replaced. NOTE: If the crankshaft speed indicator ring is damaged, the whole vibration damper assembly must be replaced. Check the mounting web for cracks. Check the alignment marks on the inner and outer rings.