Cummins — 3666003

Vibration Damper, Rubber C Series Page 1-114 Section 1 - Cylinder Block - Group 01 Check the index lines (A) on the damper hub (B) and the inertia member (C). If the lines are more than 1.59 mm [1/16 in] out of alignment, replace the damper. Inspect the vibration damper hub for cracks. Replace the damper if the hub is cracked. Inspect the rubber member for deterioration. If pieces of rubber are missing or if the elastic member is more than 3.18 mm [1/8in] below the metal surface, replace the vibration damper. NOTE: Check for forward movement of the damper ring on the hub. Replace the damper if any movement is detected. Install NOTE:

Align the crankshaft speed indicator ring and vibration damper with the index pin located on the nose of the crankshaft. Lubricate the capscrews with clean engine oil. Install the vibration damper and crankshaft speed indicator ring. Tighten the six vibration damper capscrews in a criss- cross pattern. Torque Value: Step 1 50 N•m [ 37 ft-lb ] Step 2 Rotate 90 degrees