C Series Valve, Cylinder Head Section 2 - Cylinder Head - Group 02 Page 2-21 Inspect for Reuse Inspect the valve guides for scuffing or scoring. Measure the valve guide bore. Valve Guide Bore Diameter mm in 15.988 MIN 0.6294 16.000 MAX 0.6299 If the inspection reveals damaged valve guides, refer to the Alternative Repair Manual, Bulletin 3810234. Inspect the valve seats for cracks or burned spots. Refer to the following reuse guidelines for any cracks discovered. Service valve seats are available for seats with burned spots that will require more than 0.254 mm [0.010 in] grinding to clean up.
Refer to the C Series Alternative Fuel Shop Manual, Bulletin 3810234, for valve seat installation procedures. Inspect for abnormal wear on the head and stem of the valves. Measure the valve stem diameter. Valve Stem Diameter mm ft-lb 9.48 MIN 0.373 9.50 MAX 0.374 NOTE: If the valve is not within specification, it must be replaced.