C Series Valve, Cylinder Head Section 2 - Cylinder Head - Group 02 Page 2-23 Measure the valve spring load. Valve Spring Load ft-lb @ 49.25 mm [1.94 in] 359 MIN 80.7 397 MAX 89.2 Lap Apply a thin, even coating of fine lapping compound, Part No. 3375805, on the valve face. NOTE: Use a power or hand suction lapping tool to provide pressure in the center of the valve. Turn the valve back and forth. Continue lapping the valve until the compound shows a continuous contact pattern on both the valve face and valve seat. Lapping compound is an abrasive material. Failure will result if the cylinder head, valves, and valve seats are not cleaned thoroughly.
CAUTION Clean the lapping compound from the cylinder head, valves, and valve seats. Install NOTE: All cylinder head components must be clean before installing them. Install the valve stem seals. NOTE: The intake and exhaust valve stem seals are the same.