Fuel Injection Pumps, In-Line C Series Page 5-16 Section 5 - Fuel System - Group 05 Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. WARNING WARNING When using solvents, acids, or alkaline materials for cleaning, follow manufacturer's recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury. Failure to clean and dry the shaft and gear tapers thoroughly can result in timing shift to the retarded side after the engine is started and running under a load. This will result in low power, smoke, rough running, and engine damage. CAUTION Tighten the fuel injection pump drive nut.
Make certain that the static timing has not changed after the fuel injection drive nut is tightened to the required specification. Before installing the fuel pump drive gear, clean the injection pump shaft and gear tapers with QD Contact Cleaner, Part Number 3824510, by spraying into the gap between the shaft and the gear. Dry the surface with compressed air. Tighten the fuel injection pump drive gear nut. Torque Values: Torque Value: Nippondenso Step 1 123 N•m [ 91 ft-lb ] Torque Value: Bosch A Pump Step 1 85 N•m [ 63 ft-lb ] Torque Value: Bosch MW Pump Step 1 105 N•m [ 77 ft-lb ] Torque Value:
Bosch P3000/P7100 Step 1 195 N•m [ 144 ft-lb ] Repeat this procedure as needed until the timing matches the specification.