C Series Fuel Injection Pumps, In-Line Section 5 - Fuel System - Group 05 Page 5-17 The fuel injection pump timing pin must fit over the injection pump pointer when the engine is at top dead center or on the compression stroke for the cylinder number 1. If it does not , the fuel injection pump must be adjusted by an authorized fuel injection pump shop or the fuel injection pump was installed incorrectly. Remove the degree wheel and timing mark pointer. Remove Automotive and Industrial WARNING Fuel is flammable.
Keep all cigarettes, flames, pilot lights, arching equipment, and switches out of the work area and areas sharing ventilation to reduce the possibility of severe personal injury or death when working on the fuel system. Do not use the timing pin to locate engine top dead center for marine applications. This can result in incorrect timing, poor engine performance, and engine smoke problems. CAUTION Locate top dead center for cylinder Number 1. Push the timing pin into the hole in the camshaft gear while slowly rotating the crankshaft with the barring tool, Part Number 3377371. NOTE: Make certain that the timing pin is disengaged after locating top dead center.