Cummins — 3666003

C Series Fuel Injection Pumps, In-Line Section 5 - Fuel System - Group 05 Page 5-19 Marine Applications Fuel is flammable. Keep all cigarettes, flames, pilot lights, arching equipment, and switches out of the work area and areas sharing ventilation to reduce the possibility of severe personal injury or death when working on the fuel system. WARNING CAUTION Do not use the timing pin to locate engine top dead center for marine applications. This can result in incorrect timing, poor engine performance, and engine smoke problems. Locate top dead center for cylinder number 1. See the Time, Marine Applications section. Remove the front gear cover access cap.

Remove the nut and washer from the fuel injection pump shaft. Use fuel pump gear puller, Part Number 3163381 or Part Number 3824469 with M8-1.25 x 50 capscrews, grade 8.8 or equivalent. Pull the fuel injection pump drive gear loose from the shaft. Engines equipped with P7100, P3000, A, or MW fuel injection pumps are equipped with support brackets that must be removed.