C Series Lubricating Oil Cooler Section 7 - Lubricating Oil System - Group 07 Page 7-5 Inspect the capscrews. If they are Grade 10.9 or higher, they can be reused. If the capscrews are lower than Grade 10.9, they must be replaced with Grade 10.9 or higher capscrews. Leak Test Use Leak Test Kit, Part Number 3823876, to pressure-test the lubricating oil cooler element. Air Pressure Test kPa psi 449 MIN 65 518 MAX 75 Install NOTE: Make sure to remove the shipping plugs from a new element. Assemble the lubricating oil cooler gaskets, element, and cooler cover. Use new gaskets. Tighten the capscrews in the sequence shown in the illustration, in two steps. The arrow (A) points to the dimple.
Torque Value: Step 1 24 N•m [ 212 in-lb ] Step 2 32 N•m [ 24 ft-lb ]