Lubricating Oil Dipstick C Series Page 7-6 Section 7 - Lubricating Oil System - Group 07 Finishing Steps Install the turbocharger oil supply line. Refer to Procedure 010-046 in Section 10. Install the lubricating oil filter. Refer to Procedure 007-013 in Section 7. Install the coolant filter head. Refer to Procedure 008-007 in Section 8. Fill the engine with coolant. Refer to Procedure 008-018 in Section 8. Operate the engine and check for leaks. Shut the engine OFF and check the coolant and lubricating oil levels. Lubricating Oil Dipstick (007-009) Calibrate NOTE: This procedure must begin with the oil pan drained. Refer to Procedure 007-037 (Lubricating Oil System) in Section 7.
Use clean engine oil to fill the oil pan to the specified low oil level. Refer to Procedure 018-017 (Lubricating Oil System) in Section V for the correct engine oil capacity. Install the dipstick in the dipstick tube housing. CAUTION Use care when marking the dipstick. The dipstick will break if the scribe mark is too deep. Remove the dipstick and scribe a mark across the stick at the oil level. Label the mark with an "L" to indicate the low oil level. NOTE: If a new blank dipstick is being used, cut the dipstick off approximately 38 mm [1.5 in] below the low oil level mark. Wipe off the dipstick and install it in the dipstick tube housing. Fill the oil pan to the specified high oil level.
Refer to Procedure 018-017 (Lubricating Oil System) in Section V for the correct engine oil capacity.