C Series Cooling System Section 8 - Cooling System - Group 08 Page 8-19 Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. WARNING The coolant replacement tool tank capacity of 68 liters [18 gal] is adequate for most applications. An additional storage tank can be used for cooling system packages with more than 68 liter [18 gal] capacity. Be sure there is no air pressure in the coolant replacement tool tank by opening the pressure relief valve (1) located on the control block of the coolant replacement tool. Connect the coolant replacement tool to a shop air supply regulated at 621 kPa [90 psi].
Switch the coolant replacement tool control lever (1) to “VAC” and leave the service hose valve (2) closed. This will create a vacuum in the tank to evacuate coolant from the cooling system package. Monitor the gauge (3) and build a vacuum of approximately 508 mm-Hg [20 in-Hg] in the coolant replacement tool tank. Once the vacuum has been achieved, move the control valve lever (1) to the middle position. Maintain approximately a 508 mm-Hg [20 in-Hg] vacuum to achieve a faster drain. Attach the fill hose quick disconnect coupling (1) of the coolant replacement tool to the quick disconnect fitting.
Location of the fitting may vary between OEMs, but the fitting is generally located in the lowest point of the vehicle/equipment cooling system package. NOTE: Most Volvos are equipped with a different style fitting located in the radiator. An adapter hose is needed to connect the Cummins® coolant replacement tool to the fitting. The adapter hose is included in the accessory kit. Open the service hose valve (1) by turning it clockwise until it is completely open (approximately ј turn). Additional shop air may be required to maintain enough of a system vacuum to remove the coolant from the system. This can be done by moving the control valve lever (2) back to the VAC position.