Cooling System C Series Page 8-20 Section 8 - Cooling System - Group 08 When the cooling system has been evacuated, a coolant and air mixture will be visible in the clear section of the coolant replacement tool fill hose. NOTE: Some residual coolant will settle in the coolant package as the recessed areas of the block continue to drain down over the next few minutes. Once the system has been evacuated, turn the service hose valve (1) to the closed position by turning the valve counterclockwise a ј turn. Disconnect the shop air connection from the coolant replacer tool. Disconnect the fill hose quick disconnect coupling (2) on the coolant replacement tool from the quick disconnect fitting.
Injection CAUTION The cooling system must be filled properly to prevent air locks or serious engine damage can result. The following steps are used to inject coolant into the cooling system using the coolant replacer tool, Part Number 2892459. NOTE: When the vehicle/equipment or engine is equipped with a quick disconnect fitting in the cooling system package, the Coolant Replacer Method is the preferred method for coolant removal. Use the coolant replacer tool, Part Number 2892459.
If the vehicle/ equipment or engine does not have a quick disconnect fitting presently installed, one can be installed in the cooling system package to utilize the Coolant Replacer Method; otherwise the coolant drain and fill method must be used. Cummins Inc. recommends the use of either a 50/50 mixture of good quality water and fully-formulated antifreeze, or fully-formulated coolant when filling the cooling system. The fully-formulated antifreeze or coolant must meet TMC RP329 or TMC RP330 specifications. Good quality water is important for cooling system performance.
Excessive levels of calcium and magnesium contribute to scaling problems, and excessive levels of chlorides and sulfates cause cooling system corrosion. Cummins Inc. recommends the use of Fleetguard® ES COMPLEAT™. It is available in glycol forms (ethylene and propylene) and complies with TMC RP329 and RP330 standards. Refer to Cummins® Coolant Requirement and Maintenance, Bulletin 3666132, for more engine coolant specifications. Water Quality Calcium Magnesium (Hardness) Maximum 170 ppm as (CaCO + 3 MgCO ) 3 Chloride 40 ppm as (Cl) Sulfate 100 ppm as (SO ) 4