C Series Cooling System Section 8 - Cooling System - Group 08 Page 8-21 Opening the manual bleed valve or removing the pipe plug on applicable installations is critical. Failure to do so can result in engine damage. NOTE: Some applications can have a manual bleed valve or pipe plug that is required to be opened to properly fill the system. The upper radiator pipe is a common location. CAUTION If applicable, open the manual bleed valve or remove the pipe plug before filling the cooling system. Be sure there is no air pressure in the coolant replacement tool tank by opening the pressure relief valve (1) located on the control block of the coolant replacement tool.
Connect the coolant replacement tool to a shop air supply regulated at 621 kPa [90 psi]. Attach the fill hose quick disconnect coupling (1) of the coolant replacement tool to the quick disconnect fitting located in the vehicle/equipment cooling system package. With the service hose valve (2) in the closed position, switch the coolant replacement tool control lever (3) to “P” and build 172 kPa [25 psi] pressure on the gauge. Slowly open the service hose valve (2) part way by turning it counterclockwise approximately 1/8 turn. Do not open the ball valve completely as this will increase the coolant flow rate and increase the amount of air pockets created in the cooling system.
This will provide a more complete injection of coolant.