Cummins — 3666003

Cooling System C Series Page 8-22 Section 8 - Cooling System - Group 08 Fill the cooling system with coolant to the bottom of the fill neck in the radiator fill or recovery/expansion tank or until the coolant replacer tool is empty (whichever occurs first). On applications that use a coolant recovery system, check to make sure the coolant is at the appropriate level in the coolant recovery tank for the engine temperature. Many coolant recovery/expansion tanks, also called "top tanks", have sight glasses or are made of a clear material ( not shown) to aid in checking the coolant level without removing the radiator cap.

It is important to understand the impact of temperature on the expansion of the coolant. Most "top tanks" do not have a provision for a "FULL HOT" coolant level. Filling the "top tank" while hot will result in a low operating level once the system has cooled. The cooling system must be filled properly to prevent air locks or serious engine damage can result. NOTE: If all coolant drained from the system was collected, the same volume or more must go back into the system. If any drained coolant remains in the tool after filling, this is an indication of an air pocket in the cooling system package which must be purged before returning the vehicle to service. NOTE:

Top off of coolant might be necessary for repairs that were performed to correct a coolant loss issue. CAUTION If all coolant drained from the system would not return to the system or the level is above the maximum level. This is an indication of an air pocket in the cooling system package, which must be purged before returning the vehicle to service. To remove an air pocket from the cooling system, the coolant replacement tool can be used. Refer to the vacuum section of this procedure. Once the coolant level has been returned to the correct level close the service hose valve (1) by turning the valve clockwise until closed.

Remove pressure from the coolant replacement tool tank by opening the pressure release valve on the back of the control block (2). Disconnect the service hose quick disconnect coupling (3) from the quick disconnect fitting of the vehicle/equipment.