C Series Cooling System Section 8 - Cooling System - Group 08 Page 8-23 Vacuum The following steps are used to place a vacuum on the cooling system using the coolant replacer tool, Part Number 2892459. Be sure there is no air pressure in the coolant replacement tool tank by opening the pressure relief valve (1) located on the control block of the coolant replacement tool. Clamp off any vent hoses/connections or overflow to the cooling system. Attach the coolant dam handle (1) to the fill hose of the coolant replacement tool. Attach the appropriate size coolant dam rubber adapter (1) onto the coolant dam handle.
The size of the fill neck will differ between OEMs choose the appropriate sized coolant dam rubber adapters. Connect the coolant replacement tool to shop air regulated at 621 kPa [90 psi].