Cummins — 3666003

C Series Cooling System Section 8 - Cooling System - Group 08 Page 8-25 Use caution when draining coolant that coolant is not spilled or drained into the bilge area. Do not pump the coolant overboard. If the coolant is not reused, it must be discarded in accordance with local environmental regulations. CAUTION Drain the engine cooling system by opening the drain valve on the engine oil cooler (exhaust side of engine). A drain pan with a capacity of 31.7 liters (8 gal) will be adequate in most installations. Remove the pressure cap to allow the coolant to drain properly. After the cooling system is completely drained, close the drain valve.

All Applications Except Marine Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. WARNING WARNING Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. Avoid excessive contact, and wash thoroughly after contact. Keep out of reach of children. Drain the cooling system by opening the drain valve on the radiator and removing the plug in the bottom of the water inlet hose. A drain pan with a capacity of 19 liters [5 gal] will be adequate for most applications.

Check for damaged hoses and loose or damaged hose clamps. Replace as required. Check the radiator for leaks, damage, and buildup of dirt. Clean and replace as required.