C Series Cooling System - Air or Combustion Gas Test Section 8 - Cooling System - Group 08 Page 8-31 Never use water alone for coolant. This can result in damage from corrosion. CAUTION Use a mixture of 50-percent water and 50-percent ethylene glycol or propylene glycol antifreeze to fill the cooling system. WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. Install the pressure cap. Operate the engine until the coolant reaches a temperature of 80°C [176°F], and check for coolant leaks.
Operate the engine at idle for 25 minutes to purge the air from the cooling system. Turn all cab heater temperature switches, if equipped, to high to allow maximum coolant flow through the heater core(s). The blower does not have to be on. Check the coolant level again to make sure the system is full of coolant or that the coolant level has risen to the hot level in the recovery bottle on the system, if so equipped. Cooling System - Air or Combustion Gas Test (008-019) General Information Overflow Method WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap.
Heated coolant spray or steam can cause personal injury. Allow the engine to cool, and remove the cooling system pressure cap.